Microlab 600 Ethernet Connection Troubleshooting Guide for Windows
The Microlab 600 requires a specific IP configuraton to be discoverable by some PCs. Below are a few steps to try if you are having difficulty connecting your device via ethernet.
- Go to the Network and Sharing Center and select the Microlab 600 connection
- Go to Properties
- Make sure TCP 4 is enabled and highlighted and click Properties
- Fill in the settings as:
- IP Address 192.168.100.50
- Subnet 255.255.255.0
- Fill in the settings as:
- Under the ethernet link for your Microlab 600, go to properties in the sharing tab configure as seen below, (You may not have the same services available) and enable all services available on your computer. Go into settings and create a new Service called Microlab 600.
- Configure the service as:
- IP 192.168.1.1
- TCP External and Internal as 2000
- Configure the service as:
